Wroclaw University of Technology De Gruyter Open Materials Science
Materials ScienceAn interdisciplinary Journal of Physics, Chemistry and Technology of Materials
Aims and Scope Editorial Board Accepted Papers Current Issue Back Issues Instructions for Authors Copyright Information Permissions for reprinting Distribution & Subscription

Back Issues

The section contains back issues papers
of Materials Science-Poland.

Evaluation Study of Cast Al-SiCp Composites

J. T. Al-Haidary1, A. S. Jabur Al-Kaaby2
1Dept. of Materials and Metallurgical Eng., Al-Balqa Applied University, Al-Salt
2Dep. Of Prod. Eng. And Metallurgy,University of Technology, Baghdad-Iraq

 Show abstract  pdf Download article (PDF)
Scaling of Nonvolatile Memories to Nanoscale Feature Sizes

T. Mikolajick, N. Nagel, S. Riedel, T.Mueller, K.-H. Küsters
Infineon Technologies Dresden, Technology Center Flash IFD TC FL, Dresden, Germany

 Show abstract  pdf Download article (PDF)
Effect of dislocation density on the efficiency of multicrystalline silicon solar cells

Z. Benmohamed, M. Remram
Electronic Department, University of Constantine, Algeria

 Show abstract  pdf Download article (PDF)
Microstructure of Austenitic Steel after Oscillatory Compression Test

Grzegorz Niewielski, Dariusz Kuc, Kinga Rodak
Silesian University of Technology, Department of Materials Science, Katowice, Poland

 Show abstract  pdf Download article (PDF)
Effect of lanthanum on the tensile properties of carbon-fibre reinforced thermoplastic polyimide composites

Jian Li1, Xianhua Cheng1,2
1 School of Mechanical & Power Engineering, Shanghai Jiao Tong University, Shanghai, P.R. China
2 The State Key Laboratory of Tribology, Tsinghua University, Pekin, P.R. China

 Show abstract  pdf Download article (PDF)
Photoinduced degradation in electrical properties of normally and obliquely deposited As2Se3 thin films

Priyamvada Bhardwaj1, P.K. Shishodia2, R. M. Mehra1
1 Department of Electronic Science, University of Delhi South Campus, New Delhi, India
2 Department of Physics & Electronics, Zakir Husain College, New Delhi, India.

 Show abstract  pdf Download article (PDF)
From the Workshop Organizers

K. Maruszewski, E. Zschech

pdf Download article (PDF)
Some aspects of mechanochemical reactions

K. Wieczorek-Ciurowa, K.Gamrat
Cracow University of Technology, Institute of Inorganic Chemistry and Technology, Cracow, Poland

 Show abstract  pdf Download article (PDF)
Submicron-sized hybrid SiO2-Ni0 powders produced by the sol-gel method

B.Borak1, S.Laskowski2, O.Heczko3, A.Aaltonen3, A.Baszczuk4, M.Jasiorski5, O.Söderberg3, B.Mazurek2, M.Oja6, S-P.Hannula3, K.Maruszewski1,2
1Institute of Material Sciences and Applied Mechanics, Wroc³aw University of Technology, Wroc³aw, Poland
2Electrotechnical Institute, Wroc³aw, Poland
3Laboratory of Materials Science, Helsinki University of Technology, Finland
4Institute for Low Temperature and Structure Research, Polish Academy of Sciences, Wroc³aw, Poland
5Institute of Inorganic Chemistry and Metallurgy of Rare Elements, Technical University of Wroc³aw, Wroc³aw, Poland
6Laboratory of Mechanical Process Technology and Recycling, Helsinki University of Technology, Finland

 Show abstract  pdf Download article (PDF)
Influence of thermo-mechanical properties of polymer matrix on thermal conductivity of adhesives for microelectronic packaging

J. Felba, T. Fa³at, A. Wymys³owski
Faculty of Microsystem Electronics and Photonics, Wroclaw University of Technology, Wroc³aw, Poland

 Show abstract  pdf Download article (PDF)
Transport properties of as-deposited cadmium phthalocyanine Schottky-barrier devices.

Mammen Samuel, C.S. Menon, N.V. Unnikrishnan.
School of Pure & Applied Physics, Mahatma Gandhi University, Kerala, India.

 Show abstract  pdf Download article (PDF)
Analysis of the some properties of model system from low-melting illite clay and fibrous mineral wool waste

V. Balkevičius1, J. Christauskas2, A. Gailius2, A. Špokauskas1, V. Siaurys1
1 Institute of Thermal Insulation, Vilnius Gediminas Technical University, Vilnius, Lithuania
2 Vilnius Gediminas Technical University, Vilnius, Lithuania

 Show abstract  pdf Download article (PDF)
Polishing of Poly Methyl Methacryate, Polycarbonate and SU-8 Polymers

Z.W. Zhong1, Z.F. Wang2, Zirajutheen B.M.P.1, Y.S. Tan1, Y.H. Tan1
1 School of Mechanical and Aerospace Engineering, Nanyang Technological University, Singapore
2 Singapore Institute of Manufacturing Technology, Singapore

 Show abstract  pdf Download article (PDF)
The solidification behaviors of CuCr alloys under different cooling rates

Youhong Wang1,2, Xiaoping Song1, Zhanbo Sun1, Xuan Zhou1, Juan Guo1
1School of Science, Xi'an Jiaotong University, Xi'an, P. R. China
2Institute of Materials Science and Engineering, Taiyuan Science and Technology University, Taiyuan, P. R. China

 Show abstract  pdf Download article (PDF)
Influence of Milling Time on the Performance of Ceramic Ball Grinding Media Prepared From Refractory Waste

Lianyun Zhong1,2,3, Bolin Wu2,3, Lianmeng Zhang1, Jieguang Song1,2
1 State Key Lab of Advanced Technology for Materials Synthesis and Processing, Wuhan University of Technology, Wuhan, P. R. China
2 Key Lab of Nonferrous Materials and New Processing Technology (Guangxi University, Guilin University of Technology ) of Ministry of Education, Guilin, Guangxi, P. R. China;
3 Department of Materials and Chemical Engineering, Guilin University of Technology, Guilin, P. R. China


Aluminosilicate refractory waste was used to prepare high performance ceramic balls grinding media with 75% Al2O3. The influences of milling time on the particle size of raw materials, the sintering temperature and performance of ceramic balls were studied. The results showed that with increasing milling time the particle size of the raw materials decreased resulting in the decreased of ceramic balls sintering temperature and the increased of wear resistance and volume density. The wear rate and volume density of the balls prepared by the materials milled for 72h were 0.01886%/h and 3.374g/cm-3, respectively.

 Hide abstract  pdf Download article (PDF)
Energetics, electronic structure and structure stability of calcium alloying Mg17Al12 phase from a first-principle calculations

D.W.Zhou, P.Peng, J S Liu
School of Materials Science and Engineering, Hunan University, Changsha, P.R.China

 Show abstract  pdf Download article (PDF)
Strain state in silicon structures for microprocessor technology

M. Hecker, H.Geisler
AMD Saxony LLC & Co. KG, Materials Analysis Department, Dresden, Germany

 Show abstract  pdf Download article (PDF)
PTFE-Encapsulation for Pentacene based organic Thin-Film Transistors

C. Pannemann1, T. Diekmann1, U. Hilleringmann1, U. Schürmann2, M. Scharnberg2, V. Zaporojtchenko2, R. Adelung2, F. Faupel2
1 University of Paderborn, Department EIM-E / Sensorik, Paderborn, Germany
2 University of Kiel, Chair for Multicomponent Materials, Technical Faculty, Kiel, Germany

 Show abstract  pdf Download article (PDF)
Optimization of Carbon Fibers Made up of Commercial Polyacrylonitrile Fibers Using Screening Design Method

R.E. Farsani1,2, S. Raissi1, A. Shokuhfar2, A. Sedghi3
1Islamic Azad University-South Tehran Branch, Tehran, Iran.
2Faculty of Mechanical Engineering, K. N. Toosi University of Technology, Iran
3Faculty of Engineering, IKI University, Qazvin, Iran

 Show abstract  pdf Download article (PDF)
Fabrication of Al-4.5% Cu alloy with fly ash metal matrix composites and its characterization

Mahendra K.V.1, Dr.K.Radhakrishna2
1Research scholar, BMSCE, Bangalore, India
2Mechanical dept. BMS College of Engineering, Bangalore, India

 Show abstract  pdf Download article (PDF)
Study of Nb-Zn codoped Ba(Ti,Zr)O3 ceramics

Yuehui Wang1, Zhiqiang Zhuang2, Ji Zhou1
1 State Key Laboratory of New Ceramics and Fine Processing, Department of Materials Science and Engineering, Tsinghua University, Beijing, People's Republic of China
2 College of Materials Science and Engineering, South China University of Technology

 Show abstract  pdf Download article (PDF)
Changes of structural, optical and electrical properties of sol-gel derived ZnO films with their thickness

A. Jain, P. Sagar, R. M. Mehra
Department of Electronic Science, University of Delhi South Campus, New Delhi, India

 Show abstract  pdf Download article (PDF)
The influence of γ-Al2O3 and Na2O on the calcium silicate hydrates formation in the CaO-quartz-H2O system

K.Baltakys, R.Siauciunas
Department of Silicate Technology, Kaunas University of Technology, Kaunas, Lithuania

 Show abstract  pdf Download article (PDF)
Experimental challenges for approaching local strain determination in Silicon by Nano-Raman spectroscopy

L.Zhu1,2, J.Atesang1,3, P.Dudek1,4, M.Hecker1, J.Rinderknecht1, Y.Ritz1, H.Geisler1, U.Herr2, R.Geer3, E.Zschech1
1AMD Saxony LLC & Co. KG, Materials Analysis Department, Dresden, Germany
2University of Ulm, Materials Department, Ulm, Germany
3University at Albany-SUNY, College of Nanoscience and Engineering, Albany NY, USA
4Wroc³aw University of Technology, Faculty of Microsystem Electronics and Photonics, Wroclaw, Poland

 Show abstract  pdf Download article (PDF)
Photovoltaic performance of dye-sensitized ZnO solar cell based on Eosin-Y photosensitizer

Poonam Suri, Manoj Panwar, R. M. Mehra
Department of Electronic Science, University of Delhi South Campus, New Delhi, India

 Show abstract  pdf Download article (PDF)